Input: 12V DC Transmitting Power: 10MW Up to 5 Remote Control

Input: 12V DC Transmitting Power: 10MW Transmitting Frequency: 433 MHz Up to 30 Remote Control

Input Power: AC190 - 265 V 50 - 60 Hz Output Power: DC 12V±15% Output Current: I (Max.) -5A Storage Battery: 2 V - 7 Ah

Input Power: AC190 - 265 V and 50 - 60 Hz Output Power: DC 12V ± 15% Output Current: I (Max.) - 3A Storage Battery: 2 V - 7 Ah

Pet Immunity: Up to 18 kg, 60 cm Detection Range: 12 x 12 m, 110⁰C - 25⁰C Detectable Speed: 0.3 - 1.5 m/s

Detection distance: 8 m Max. Covering Area: 8 x 1 m/ 90° Alarm extremity output indication: Red LED indicator lights for 6 seconds

Double Twin Optic Detection Technology Surface Mounted Component Technology, Greater EMI, and RFI Immunity Automatic Temperature Compensation

PIR360 Adopt Advanced and Stable Circuit Design Coverage: 360° (12m x 12m) Alarm Time: 1.5 - 2.5 s

Outdoor Dual Technology Detector DTX100 is a special three-tech (PIR+PIR+MW+ASIC) complex detector for outdoor intrusion Coverage: 100⁰ (12 x 12m)

Automatic Setting of Anti-Masking Microwave Synchronization Selectable Detection Sensitivity

Detection Range: 15 x 15 m at 25⁰C Infrared Sensor: Low Noise and Dual Element (Microwave Sensor and Infared Sensor) Microwave Sensor: DRO w/m Micro Strip Antenna

Detection Range: Up to 10m Input Voltage: 9 to 16V DC Current Drain: About 15 mA @12V DC Alarm Output: Solid State Relay, N.C., Up to 100 mA/ 30 V

Exact Function of the Master Keypad Except the Built-in Microphone Simply Connected in parallel with the Master Keypad Weatherproof, back-lit housing iV IP54

Detection Range: Radius of 180 cm Detection Mode: Piezoelectric Special Feature: No power supply is required, accurately and effectively detect the strike of glass

Voltage: 9 - 16V DC Current: 17 mA Coverage: High: 9 m, Low: 4.5 m Relay Output: 150 mA/28V DC N.C

Highly Sensitive and Very Reliable Built-in Transmitter to Send Alarm Signal Equipped with Backup Battery Buzzer Sound Level: 85 dB/ 0.3 m

Input Voltage: 16 - 32V DC Alarm Current: 10 to 100 mA max Standby Current: 60 µA Average, 90 µA Peak @24V DC Env. Temperature: 32 to 140˚F Sensitivity: Normally set at 10%/50 cm

Input Voltage: 16 - 32V DC Alarm Current: 10 to 100 mA max. Standby Current: 35µA @24V DC

Input Voltage: 16 - 32V DC Alarm Current: 10 to 100 mA max. Operating Temperature: 32°F - 100°F

Input Voltage: 16 - 32V DC Alarm Current: 10 to 100 mA max. Standby Current: 60 µA Average, 90 µA Peak @24V DC

Rated Voltage: 12V DC Flash Frequency: 150 time/sec SPL dB: 115 dB/ 1 m Housing: ABS

Single Siren Tone Use for Outdoor Siren Output: 115 dB (1 m)

Piezo Diaphragm: Single Piezo Piezo Diameter: 50 mm Rated Voltage: 12V DC Operating Voltage: 6 - 14V DC Min. SPL: 108±2 dB at 12V DC/1 m Max. Rated Current: 710 mA at 12V DC

Piezo Diaphgram: Two Piezo Piezo Diameter: 50 mm Rated Voltage: 12V DC

Voice Call Impedance: 4/8/12 Ohm Voice Call Dimension: 25.4 mm Rated Voltage: 12V DC Operating Voltage: 6 - 15V DC Min. SPL: 105 dB at 12V DC/1 m Max. Rated Current: 650 mA at 12V DC

Jumbo Outdoor/Indoor Siren with Flashing Light Rated Voltage: 12V DC Maximum Sound Pressure Level: 118 dB at 12V DC/ 100 cm

Power Source: 16.5 AC VDC, 1.5 Amp Protection Zones: 8 Protections zones, and Off-line resistor supervised Control Station: Full function control station, 4 in parallel max.

6 Zones with Auto-Dialer and Communication Up to 2 x 32 Digit Telephone Numbers for Communicator Remote Arm-Disarm from any DTMF (Telephone or Mobile Phone)

2 Zones with Door Chime 2 Zone Types: Instant Zone and Delayed Zone 2 Sensing Terminals: Delayed Loop and Instant Loop (Compatible with N.0 and N.C Loop Devices) 24-hour door crime terminal for N.O buttons

16 Zones Built-in voice modules with 20-second voice record length 3 Arming Modes: Keypad, Remote Control & Telephone